Price List
Installation Instructions
This Months AD
Photo Gallery
Shrewd Precision
Innovative Mold Inc
Archery Shooters Assn
IBO
NFAA
Mathews Inc.
Muzzy
Custom Bow Equipment
ArcheryTalk.com
Wizards Web Consulting

Copyright 2004 LP Archery Products, LLC all rights reserved.

Website Developed and Hosted By Wizards Web Consulting, Specializing in Archery related sites.

Trophy Ridge Sight, LED Installation

  1. Remove 1” long 10-32 bolt, washer & nut from Hardware Kit.

  2. Remove current top or bottom bolt from Trophy Ridge Sight and place the washer onto the 1” long bolt.

  3. Screw the 1” bolt into the sight and tighten it down.

  4. Install the LED cable clamp, washer & nut onto the bolt.  DO NOT TIGHTEN NUT COMPLETELY.

  5. Slip LED Assembly with black end cap through cable clamp.  Align LED with 1 to 3 of the fibers.  Tighten down 10-32 nut.  If using the 10-32L Sight Pin Light, black end cap may be left off.

  6. Check alignment by plugging into the Power/Control pack. Adjust position if necessary.

  7. Proceed to Pro-Light DX LED & Power/Control Pack Installation instructions, Step 2.


Back to Menu

 

 

LP Archery Products, LLC nor Pro-LIGHT DX Warranty covers a scope or sight that has been damaged by adding a tapped hole incorrectly.  Be sure that whomever adds tapped hole to scope or sight is qualified to do so correctly.